10
11
SAFETY
Recommendation
14. Never transport the machine while the drive is running.
15. Never put hands or feet on or underneath rotating parts.
Always stay away from the ejection opening.
16. Switch off the motor and pull the plug out of the socket.
Make sure that all moving parts have come to a complete
stop:
a. Whenever you leave the machine;
b. before you remove blockages or clear blockages in the
ejection channel;
c. before checking, cleaning or working on the machine;
d. after contact with a foreign body. Inspect the machine
for damage and carry out the necessary repairs before
you start again and work with the machine.
17. If the machine starts to vibrate unusually strong, an
immediate check is necessary;
a. look for damages;
b. carry out the necessary repairs of damaged parts;
c. check for loose parts and tighten them.
18. Keep children away from the scarifier and the connection
cable.
19. Do not leave children unattended during operation.
1. The machine should be operated via a residual current
device (RCD) with a trigger current of no more than 30 mA.
2. Do not operate the machine in bad weather conditions,
especially not in case of danger of lightning.
SAFETY
Vibration and Noise Reduction
Emergency
Familiarize yourself with the use of the product by reading
the manual completely. Remember the safety instructions
and follow them carefully. This will help you to avoid risks
and dangers.
To reduce the influence of vibration and noise, limit working
hours and wear personal protective equipment.
Observe the following points to keep the vibration and noise
exposure low:
1. Always be attentive when using the product so that
you can identify and react to hazards at an early stage.
Rapid intervention can prevent serious injury and damage
to property.
1. Use the product only as intended according to the design
and instructions.
2. Make sure that the product is in a good condition and well
maintained.
3. Use the correct accessories and ensure that it is in good
condition.
4. If excessive vibrations occur, e.g. due to a jammed stone,
turn off the machine, disconnect it from the power supply
and check the roller. If necessary, have the machine
checked by a specialist.
5. Hold the product firmly but not cramped by the handles
provided.
6. Maintain the product according to this manual and keep it
well lubricated.
7. Plan your working hours according to these operating
instructions in order to distribute a higher load over a
longer period of time.
