22
23
DESCRIPTION OF PRODUCT
The illustration of the principal functioning parts can be found
on the front and back foldout pages.
1. Handle Bar
2. Clutch bar
3. 4 x Screw
4. 4 x Washer
5. Upper Handle Bar
6. 4 x Quick Clamp
7. Lower Handle Bar
8. 2 x Handle Support
9. 2 x Adjusting Screw
10. 2 x Toothed Lock Washer
11. Cutting Device (tines)
12. Suspension
13. 3 x Plug
14. 3 x Screw for Suspension
15. Scarifying Roller
16. Scarifying Depth Adjustment
17. Cover Flap
18. Carrying Handle
19. Grass Catcher Frame
20. 2 x Wire Clip
21. Grass Catcher
22. Power Cable
23. Cable Protection
24. Start Button
25. Power Supply
INSTALLATION
Check scarifier and scope of delivery
Assembly
Danger of damage!
Assmebly the Handle Bars
WARNUNG!
NOTE!
If you open the packaging carelessly with a sharp knife or
other pointed objects, the scarifier can quickly be damaged.
Make sure that the scarifier is completely assembled
before using it.
– Proceed very carefully when opening.
1. Take the scarifier out of the packaging.
2. Check that the delivery is complete (see Fig. A and list on
page 6).
3. Check whether the scarifier or the individual parts are
damaged. If this is the case, do not use the scarifier.
Contact the manufacturer via the service address stated
on the warranty card.
1. Place the lock washers
10
into the Handle Support
8
(see
fig. B). Make sure that the toothed lock washer marked
“R” or “L” is mounted on the correct side, otherwise the
handlebar height cannot be adjusted correctly.
2. Place one Lower Handle Bar
7
on each toothed lock
washer. Make sure that the bends of the struts point
inwards.
3. Place the Adjusting screws
9
on the struts and tighten
them. You now have two struts screwed on.
4. Keep the Upper Handle Bar
5
lying against each other.
5. Insert two screws
3
through the holes so that the heads
point inwards and the threads outwards.
6. Place a washer
4
on each screw.
