ALTERNATOR
12-22
TNV DI Service Manual
Dynamo
3. Reinstall the front bearings (Figure 12-28, (5))
and spacer (Figure 12-28, (6)).
4. Reinstall the flat washer (Figure 12-28, (4)),
flywheel (Figure 12-28, (3)), pulley half
(Figure 12-28, (2), and through bolt
(Figure 12-28, (1)).
Figure 12-28
5. Reinstall the flat washer (Figure 12-29, (4)),
lock washer (Figure 12-29, (3)), and nut
(Figure 12-29, (2)). Tighten the nut to the
specified torque.
6. Reinstall the rear cap (Figure 12-29, (1)).
Figure 12-29
Installation of Dynamo
1. Position the dynamo on the gear case. Loosely
reinstall the nut (Figure 12-30, (2)) on the gear
case stud and the V-belt adjuster bolt
(Figure 12-30, (1)).
Figure 12-30
2. Reconnect the dynamo output wire connector.
3. Reinstall the V-belt. Tighten the V-belt to the
proper tension as described in Check and
Adjust Cooling Fan V-Belt on page 5-22.
4. Start the engine. Listen for any unusual sounds
from the alternator.
5. Verify that the charge indicator is ON while the
engine is operating. If the charge indicator is
not ON, repair the problem before operating the
engine.
(6)
(5)
(4)
(3)
(2)
(1)
0002144
(1)
(2)
(3)
(4)
0002143
CAUTION
Do not operate the engine if the
alternator is producing unusual sounds.
Damage to the alternator will result.
0000039en
0002141
(1)
(2)
TNV_DI_SM_A4.book 22 ページ 2007年12月6日 木曜日 午前9時23分
Summary of Contents for 3TNV82A-B
Page 8: ...INTRODUCTION 1 2 TNV DI Service Manual This Page Intentionally Left Blank TNV_DI_SM_A4 book 2...
Page 18: ...SAFETY 3 2 TNV DI Service Manual This Page Intentionally Left Blank TNV_DI_SM_A4 book 2...
Page 320: ...TURBOCHARGER 10 2 TNV DI Service Manual This Page Intentionally Left Blank TNV_DI_SM_A4 book 2...