Yanmar 3TNV82A-B, Service Manual

Page: 292 / 394

COOLING SYSTEM
8-8
TNV DI Service Manual
Engine Coolant System Check
ENGINE COOLANT SYSTEM
CHECK
Check the engine coolant system for leakage.
1. With the radiator properly filled, install a cooling
system tester (Figure 8-3, (1)).
Figure 8-3
2. Apply 10.8 - 14.8 psi (75 - 105 kPa; 0.75 - 1.05
kgf/cm²) to the cooling system. If the pressure
reading drops, the engine coolant system is
leaking. Identify the source of the leak and
repair it.
ENGINE COOLANT PUMP
Removal of Engine Coolant Pump
Verify the condition of the engine coolant pump
before disassembling it from the engine. Check the
engine coolant pump shaft bearing for abnormal
noise, sticking, excessive play and water leakage.
Replace the coolant pump if any of these conditions
are present.
IMPORTANT
Make sure the engine and engine coolant
are not hot.
1. Before removing the engine coolant pump or
thermostat, it will be necessary to drain the
engine coolant. Drain the coolant into a clean
container if the coolant is to be reused.
Otherwise, properly dispose of the coolant.
2. Remove the radiator cap (Figure 8-4, (1)).
3. Remove the drain plug or open the drain cock
(Figure 8-4, (1)) at the lower portion of the
radiator and drain the coolant.
Figure 8-4
4. Drain the coolant from the engine block.
• On models equipped with an oil cooler, remove
the coolant hose (Figure 8-5, (1)) at the oil
cooler.
Figure 8-5
CAUTION
If the engine coolant pump must be
replaced, replace the engine coolant
pump as an assembly only. Do not
attempt to repair the engine coolant
pump or replace individual components.
0000041en
(1)
0000577A
FULL
LOW
0000074A
(2)
(1)
(1)
0001579B
TNV_DI_SM_A4.book 8 ページ ２００７年１２月６日 木曜日 午前９時２３分