Yanmar 3TNV82A-B, Service Manual

Page: 112 / 394

PERIODIC MAINTENANCE
5-22
TNV DI Service Manual
Periodic Maintenance Procedures
* Consult the operation manual for the driven
machine for applicability of the dust proof
filter.
4. Add new engine oil to the engine as specified in
Adding Engine Oil on page 4-17.
5. Warm up the engine by running it for five
minutes and check for any engine oil leaks.
6. After engine is warm, shut it off and let it sit for
10 minutes.
7. Recheck the engine oil level.
8. Add engine oil (Figure 5-3, (5)) as needed until
the level is between the upper (Figure 5-3, (2))
and lower lines (Figure 5-3, (3)) shown on the
dipstick (Figure 5-3, (1)).
Figure 5-3
9. Reinstall the oil filler cap (Figure 5-3, (4)). If
any engine oil is spilled, wipe it away with a
clean cloth.
Check and Adjust Cooling Fan V-Belt
The V-belt will slip if it does not have the proper
tension. This will prevent the alternator from
generating sufficient power. Also, the engine will
overheat due to the engine coolant pump pulley
slipping.
Check and adjust the V-belt tension (deflection) as
follows:
1. Press the V-belt down with your thumb with a
force of approximately 22 ft·lb (98 N·m; 10 kgf)
to check the deflection.
There are three positions to check for V-belt
tension (Figure 5-4, (A), (B) and (C)). You can
check the tension at whichever position is the
most accessible. The proper deflection of a used
V-belt at each position is:
Engine Oil Filter Part No.
Standard Dust proof *
3TNV82A
3TNV84
- 4TNV98
3TNV82A-B
3TNV88-B
- 4TNV98-Z
4TNV98-E
129150-35153
119005-35151
4TNV98T
4TNV98T-Z
4TNV106,
4TNV106T
119005-35151
CAUTION
• NEVER overfill the engine with engine
oil.
• ALWAYS keep the oil level between the
upper and lower lines on the oil
cap / dipstick.
0000015en
(3)
(1)
(2)
(4)
(4)
(5)
0000007C
TNV_DI_SM_A4.book 22 ページ ２００７年１２月６日 木曜日 午前９時２３分