Yamatake Corporation
6-18
ST3000 Smart Transmitter Series 900 Electronic Differential Pressure/Pressure Transmitter
6-5 : Data printing
6-5-1 :Overview of printing function
Introduction
To carry out correct flow rate measurement, it is important to check the internal setting
or response from the transmitter before starting to operate the transmitter or while the
transmitter is in operation. At this time, it is convenient if you use the SFC with a
printer to communicate with the transmitter and print out data. The SFC with a printer
has two types of printing functions as defined below.
Definition
Configuration printout (data printout)
The SFC printer can print out internal data of the transmitter such as the transmitter tag
number (TAG No.), damping time constant, low flow cutoff. This printing function is
called “configuration printout” or “data printout”.
Action printout (continuous printout):
The SFC is provided with a function that continuously prints out results of responses
to key operations of the SFC from the transmitter. This printing function is called
“action printout” or “continuous printout”.
Printer
The optional SFC printer is a 24 characters/line thermal printer. When the power
switch to the SFC is turned ON, the printer automatically starts to move and stops after
moving back-and-forth once. At this time, the recording paper will advance a little
(approximately 5 mm).
Advancing recording paper
To advance recording paper, press
+
.
The screen will display “PRINTER FEED” and the recording paper is advanced by
one line. While this prompt is displayed, the recording paper is advanced by one line
every time the
key is pressed.
To cancel the feed function, press the
key.
Feeding recording paper
When the printer is running short of recording paper, feed the paper roll compartment
with a paper roll. For a detailed procedure, see the SFC User's Manual (CM2-SFC100-
2001).
SHIFT
O
8
FEED
O
8
FEED
CLR
( No )
