Basic components
22
●
Changing the display format
●
Pressing the “
” (mode) button chang-
es the display format in the following pat-
tern:
●
Total hours
→
Trip hours
→
Display off
●
Resetting the trip hours
●
Simultaneously pressing the “
” (set)
and “
” (mode) buttons for more than
1 second while the trip hours are displayed
resets the trip counter to 0 (zero).
NOTE:
The total number of hours the engine has
been run cannot be reset.
EMU26690
Trip meter
This gauge displays the distance the boat
has traveled since the gauge was last reset.
Press the “
” (mode) button repeatedly
until the indicator on the face of the gauge
points to “
” (trip). To reset the trip meter
to zero, press the “
” (set) and “
”
(mode) buttons at the same time.
NOTE:
●
The trip distance is shown in kilometers or
miles depending upon the unit of measure-
ment selected for the speedometer.
●
The trip distance is kept in memory by bat-
tery power. The stored data will be lost if
the battery is disconnected.
EMU26700
Clock
Press the “
” (mode) button repeatedly
until the indicator on the face of the gauge
points to “
” (time). To set the clock, be
sure the gauge is in the “
” (time) mode.
Press the “
” (set) button; the hour display
will begin blinking. Press the “
” (mode)
button until the desired hour is displayed.
Press the “
” (set) button again, the minute
display will begin blinking. Press the “
”
(mode) button until the desired minute is dis-
played. Press the “
” (set) button again to
start the clock.
NOTE:
The clock operates on battery power. Dis-
connecting the battery will stop the clock.
Reset the clock after connecting the battery.
EMU26710
Fuel gauge
The fuel level is indicated by eight segments.
When all segments are showing, the fuel
tank is full.
CAUTION:
ECM00860
The Yamaha fuel tank sensor differs from
conventional sensors. Incorrectly setting
the selector switch on the gauge will give
false readings. Consult your Yamaha
dealer on how to correctly set the selec-
✩✱✣✬✤✧✲✣ ✥✥
©
2019 Yamaha Motor Corporation, U.S.A.
