Yamaha YZ125 2009, Owner'S Service Manual

Page: 49 / 234

2-18
CABLE ROUTING DIAGRAM
1. High tension cord
2. "ENGINE STOP" button lead
3. Ignition coil lead
4. Clamp
5. CDI unit
6. CDI unit band
7. Radiator breather hose
8. CDI magneto lead
9. Connector cover
10. Throttle cable
11. Clutch cable
12. CDI unit stay
A. Pass the high tension cord to the left of the
radiator hose.
B. Using a plastic locking tie, clamp the "EN-
GINE STOP" button lead, ignition coil lead
and CDI magneto lead together with the
clamp ends backward and then cut off the
tie end.
C. Clamp to the frame the throttle cable,
clutch cable, ignition coil lead and "EN-
GINE STOP" button lead. In so doing,
clamp the ignition coil lead and "ENGINE
STOP" button lead at their protecting
tubes. Tighten the clamp so that the "EN-
GINE STOP" button lead is not pulled when
the handlebar is turned to the right and left.
D. Pass the CDI magneto lead and radiator
breather hose between the frame and the
radiator(right).
E. Clamp the CDI magneto lead to the frame
at its locating tape.
F. Bring the connector cover into contact with
the coupler.
G. Locate the clamp ends in the arrowed
range.
H. Insert the CDI unit band until it stops at the
CDI unit stay.
I. Pass the CDI magneto lead and radiator
breather hose between the frame and the
radiator hose so that they come within the
arrow-indicated range. Also take care so
that the CDI magneto lead passes on the
left of the radiator breather hose.