Yamaha XVZ13TF 1999, Service Manual

Page: 470 / 501

8-72
CRUISE CONTROL SYSTEM
ELEC
NOTE:
SELF DIAGNOSIS FUNCTION OF THE
CRUISE CONTROL SYSTEM
The cruise control system has a self diagno-
sis function.
Use of the function allows the self diagnosis
about the following:
1. Trouble diagnosis of the cancel switch sig-
nal.
2. Trouble diagnosis of the brake light signal.
3. Trouble diagnosis of the throttle drive sys-
tem.
Operating procedure for the self diagnosis
mode
1) Turn on the main switch.
2) Set the “CRUISE” switch to the “ON” position.
3) Start the engine.
4) Use the engine stop switch and stop the en-
gine.
5) Wait for 10 seconds.
6) Push the cruise control switch to the “SET”
and “RES” alternatively three times (total of 6
times) within 2 seconds while pressing the
cancel switch.
Then the indicator light will be lit and the
cruise control system will enter the self
diagnosis mode.
1) The “SET” and “RES” indicator lights will
then blink alternatively three times.
When the cruise control system is not failure,
the “SET” and “RES” indicator lights will be re-
mained on.
Exiting the self diagnosis mode
Perform any one of the four steps shown below.
The system will then exit the self diagnosis
mode.
1) Start the engine.
2) Turn the rear wheels.
3) Turn off the main switch.
4) Push the “CRUISE” switch to “OFF”.