Yamaha XS650SE, Shop Manual

Page: 172 / 215

E. Installing front wheel
4. Always secure the front wheel axle as
follows:
Specifications should be changed as
follows:
(PAGE 40)
5-2. REAR WHEEL
A. Removal
1. Support machine on the center stand.
2. Disconnect the drive chain. Using drive
chain cutter (special tool).
NOTE:
The chain joint should be replaced each time
the chain is cut.
3. Remove the axle nut cotter pin and axle
nut.
4. While supporting the brake caliper, pull
out the rear axle.
5. Remove the rear wheel assembly.
E. Rear wheel installation
When installing rear wheel, reverse removal
procedure taking care of following points:
1.
2.
3.
4.
5.
Lightly grease lip of rear wheel oil seals.
Make sure the brake pads are installed
properly and that there is an enough gap
to install the rear disc.
Install wheel assembly and axle. Always
use a new cotter pin on the axle nut.
Connect drive chain.
Adjust drive chain.
(PAGE 40 44)
5-3. BRAKES
Except for the following, the same procedure
can be performed for Disassembly, Inspection
and Assembly of XS650SE front and rear
brake and XS650E front brake.
D. Brake inspection and repair
Specifications should be changed as follows:
Wear limit:
6.0 mm (0.24 in)
- 116-