Perio
d
ic maintenance an
d
a
d
justment
7-9
7
To install the spark plu
g
1. Clean the surface of the spark
plug gasket and its mating sur-
face, and then wipe off any grime
from the spark plug threads.
2. Install the spark plug with the
spark plug wrench, and then tight-
en it to the specified torque.
TIP
If a torque wrench is not available
when installing a spark plug, a good
estimate of the correct torque is 1/4–
1/2 turn past finger tight. However, the
spark plug should be tightened to the
specified torque as soon as possible.
3. Install the spark plug cap.
EAUM2584
En
g
ine oil an
d
oil filter ele-
ment
The engine oil level should be checked
before each ride. In addition, the oil
must be changed and the oil filter ele-
ment replaced at the intervals specified
in the periodic maintenance and lubri-
cation chart.
To check the en
g
ine oil level
1. Place the vehicle on a level sur-
face and hold it in an upright posi-
tion. A slight tilt to the side can
result in a false reading.
2. Start the engine, warm it up for
several minutes, and then turn it
off.
3. Wait a few minutes until the oil set-
tles, remove the oil filler cap, wipe
the dipstick clean, insert it back
into the oil filler hole (without
screwing it in), and then remove it
again to check the oil level.
NOTICE:
Do not operate the ve-
hicle until you know that the en-
g
ine oil level is sufficient.
[ECA10012]
1. Spark plug gap
Spark plu
g
g
ap:
0.8–0.9 mm (0.031–0.035 in)
Ti
g
htenin
g
torque:
Spark plug:
12.5 N·m (1.25 kgf·m, 9.2 lb·ft)
1
ZAUM00
3
7
UB3MEZE0.book Page 9 Thursday, December 26, 2019 2:23 PM
