9-52
9
the battery, the main switch must be
off, and the positive lead must be con-
nected before the negative lead.
[ECB01111]
3. Install the battery holding plate by install-
ing the bolts.
4. Install the hood.
TIP
Make sure the battery leads are installed as
shown.
Fully charge the battery before installing it.
EBU32651
Jump-starting
Jump-starting the vehicle should be avoided.
The battery should be removed and charged
instead.
However, if the vehicle must be jump-started,
proceed as follows.
WARNING
EWB03430
To avoid battery explosion and/or serious
damage to the electrical system:
Do not connect the negative lead of the
jumper cable to the negative terminal of
the battery.
Do not touch the positive lead of the
jumper cable to the negative lead.
Do not reverse the polarity of the jumper
cables when connecting to the batteries.
1. Turn the key to “
” (off).
2. Remove the hood. (See page 9-10.)
3. Using a charged 12-volt battery, connect
the positive lead of the jumper cable to
the positive terminal of the battery in the
1. Positive battery lead (red)
2. Negative battery lead (black)
2
1
UB4M11E0.book Page 52 Tuesday, August 4, 2020 1:04 PM