3-5
INSP
ADJ
E
CONTROL SYSTEM
2. Adjust:
●
QSTS cable
NOTE:
If correct adjustment by using the cable
joint at the wheel end is not obtained,
adjust the cable joint on the trim nozzle end.
Adjustment steps:
●
Set the control grip in the neutral posi-
tion.
●
Set the jet nozzle in the center posi-
tion.
●
Remove the nut
1
and pivot pin
2
.
●
Loosen the locknut
3
.
●
Turn the cable joint
4
for adjusting.
Turn in
Length
b
is increased.
Turn out
Length
a
is increased.
●
Connect the cable joint
4
and pivot
pin
2
and tighten the nut
1
.
T
R
.
.
Nut:
4 Nm (0.4 m • kg, 2.9 ft • lb)
●
Tighten the locknut
3
.
T
R
.
.
Locknut:
4 Nm (0.4 m • kg, 2.9 ft • lb)
WARNING
The cable joint must be screwed in more
than 8 mm (0.31 in).
