Yamaha WaveRunner XL1200Ltd, Service Manual

Page: 187 / 244

7-38
E
– +
ELEC
INDICATION SYSTEM
Checking steps:
●
Connect the battery terminals to the
white six-pin connector as shown.
●
Disconnect the blue one-pin connector
1 and make sure the “WARNING”
lamp 2 lights.
●
Press the “A/SET” 3 and “C” 5 but-
tons at the same time. While still
pressing the two buttons, press the
“MODE” button
6 and hold all three
for more than 3 seconds. The self-indi-
cating function will then activate.
Sequential output (73 seconds/cycle)
1 Display begins operation
2 “ ”
3 All LCD readouts turn on
4 “ ” is displayed
5 “ ” is displayed
6 “ ” is displayed
7 “ ” is displayed
8 “ ” is displayed
9 “ ” is displayed
10 “ ” is displayed
11 “ ” is displayed
12 “ ” is displayed
13 “ ” is displayed
14 “ ” is displayed
15 “ ” is displayed
●
Press either button 3 , 4 , 5 , or 6 . The
self-indicating function will then stop
and the “WARNING” lamp
2 will light.
●
Reconnect the blue one-pin connector.
The “WARNING” lamp
2 will turn off.
NOTE:
If the multi-function meter has been
removed from the water vehicle, supply
DC 12 voltage to the connector (+: red, –:
black) with a battery.
NOTE:
If the “WARNING” lamp does not light,
disconnect the battery and then recon-
nect it.
NOTE:
If the “ ” message displays, recon-
nect and then disconnect the blue one-
pin connector.