TRANSMISSION OIL REPLACEMENT
3-14
3. Check:
• Transmission oil level
INSP
ADJ
Transmission oil level checking steps:
• Remove the oil check bolt
1
.
• Inspect the oil level.
NOTE:
Be sure the machine is positioned straight
up when inspecting the oil level.
W
Never attempt to remove the checking
bolt just after high speed operation. The
heated oil could spout out, causing dan-
ger. Wait until the oil cools down.
S
Oil flows out
≥
≥
Oil level is correct.
Oil does not flow out
≥
≥
Oil level is low.
Add transmis-
sion oil until oil
flows out.
Recommended oil:
Castrol R30
R
• Inspect the gasket (oil check bolt), replace
if damaged.
• Tighten the oil check bolt.
T
Oil check bolt:
9 Nm (0.9 m•kg, 6.5 ft•lb)
EC35K021
TRANSMISSION OIL REPLACEMENT
1. Start the engine and warm it up for several
minutes and wait for five minutes.
2. Place the machine on a level place and
hold it on upright position by placing the
suitable stand.
3. Place a suitable container under the
engine.
Summary of Contents for TZ250M
Page 1: ...5KE 28199 10 LIT 11626 13 41 OWNER S SERVICE MANUAL TZ250M1 M ...
Page 11: ...MEMO ...
Page 15: ...CHAPTER 7 TUNING ENGINE 7 1 CHASSIS 7 14 ...
Page 287: ...99 9 0 1x1 ...