CLUTCH
4-37
9. Install:
• Push rod
1
• Ball
2
NOTE:
Apply the lithium soap base grease on the
push rod and ball.
10.Install:
• Pressure plate
1
NOTE:
Align the arrow marks
a
on the pressure plate
the arrow marks
b
on the clutch boss.
11. Install:
• Clutch spring
1
• Screw (clutch spring)
2
T
9 Nm (0.9 m
d
kg, 6.5 ft
d
lb)
NOTE:
Tighten the screws in stages, using a criss-
cross pattern.
ENG
12.Check:
• Push lever position
Push the push lever
1
upward until it stops.
With the push lever in this position, the rear
edge
a
of the push lever should be aligned
with the center of the push lever installation
bolt
2
.
Not aligned
≥
Adjust.
13.Adjust:
• Push lever position
Push lever position adjustment steps:
• Loosen the locknut
1
.
• Turn the adjuster
2
to align the rear edge
of the push lever with the center of the
push lever installation bolt.
• Tighten the locknut.
T
Locknut:
6 Nm (0.6 m•kg, 4.3 ft•lb)
Summary of Contents for TZ250M
Page 1: ...5KE 28199 10 LIT 11626 13 41 OWNER S SERVICE MANUAL TZ250M1 M ...
Page 11: ...MEMO ...
Page 15: ...CHAPTER 7 TUNING ENGINE 7 1 CHASSIS 7 14 ...
Page 287: ...99 9 0 1x1 ...