44
Tyros4 Reference Manual
Step Recording
In the EDIT Page, you can record notes with absolutely precise timing. This Step Recording procedure is essentially the
same as that for Song Recording (
) with the exception of the points listed below:
• In the Song Creator, the End Mark position can be changed freely; in the Style Creator, it cannot be changed. This is
because the length of the Style is automatically fixed, depending on the selected section. For example, if you create a
Style based on a section of four measures length, the End Mark position is automatically set to the end of the fourth
measure, and cannot be changed in the Step Recording display.
• Recording channels can be changed in the Song Creator 1-16 tab display; however, they cannot be changed in the Style
Creator. Select the recording channel in the BASIC tab display.
• In the Style Creator, the channel data can be entered and System Exclusive data can be edited (delete, copy, or move).
You can switch between the two by pressing the [F] button. However, Chord, Lyrics, and System Exclusive data cannot
be entered.
For instructions on Step Recording, refer to
. For information on the EDIT display (Event List display), refer
.
Style Assembly
Style Assembly allows you to create a single Style by mixing the various patterns (channels) from existing internal
Styles.
1
Select the desired Style to serve as the basis for recording/edit-
ing before calling up the Style Creator display.
2
Call up the operation display.
[DIGITAL RECORDING]
[B] STYLE CREATOR
TAB [
][
] ASSEM-
BLY
3
Select the desired section (Intro, Main, Ending, etc.) for your
new Style.
First call up the SECTION Selection display by pressing one of the Section but-
tons (INTRO, MAIN, ENDING, etc.) on the panel. Then change the section as
desired by using the [6
]/[7
] buttons and actually enter the selection by
pressing the [8
] (OK) button.
You cannot select INTRO 4 and ENDING
4 sections directly via the panel opera-
tion.
NOTE
NEXT PAGE
