10
0744-527
NOTE: Some jumper cables may be
the same color but the clamps or ends
will be color-coded red and black.
7. Attach one clamp of the negative
jumper cable (black) to the negative
(-) terminal (3) of the good battery
(B); then attach the other clamp of
the negative (black) jumper cable (4)
to an unpainted metal surface (A) on
the engine or frame well away from
the dead battery and fuel system
components.
8. Stand well away from the dead bat-
tery and start the vehicle with the
good battery. Allow the vehicle to
run for several minutes applying
some charge to the dead battery.
9. Start the snowmobile with the dead
battery and allow it to run for several
minutes before disconnecting the
jumper cables.
10. Remove the jumper cables in oppo-
site order of hook-up (4, 3, 2, 1). Be
careful not to short cables against
bare metal.
NOTE: Have the battery and elec-
trical system checked prior to oper-
ating the snowmobile again.
Drive Clutch and Driven
Clutch
The drive clutch and driven clutch do not
require lubrication; therefore, no special
maintenance is required by the snowmo-
bile owner except for periodical cleaning.
However, the drive clutch and driven
clutch should be disassembled, cleaned,
and inspected by an authorized Yamaha
Snowmobile dealer after every 4000 km
(2500 miles) or seasonally, whichever
occurs first. This service is at the discre-
tion and expense of the snowmobile
owner.
When operating the snowmobile at high
altitudes, it may be necessary to change
certain component parts of the drive
clutch and/or the driven clutch. See an
authorized Yamaha Snowmobile dealer
for further information.
Drive Clutch/Driven
Clutch Alignment
The alignment between the drive clutch
and driven clutch is set at the factory.
Normally, no adjustment is necessary as
long as neither the drive clutch nor the
driven clutch is removed or disassem-
bled. However, if premature drive belt
wear is experienced or if the drive belt
turns over, the drive clutch/driven clutch
alignment must be checked. Take the
snowmobile to an authorized Yamaha
Snowmobile dealer for this service. If not
under warranty, this service is at the dis-
cretion and expense of the snowmobile
owner.
Fuel Pump
The fuel pump is designed to provide
adequate amount of gas to the
injectors
at all throttle settings. If a fuel delivery
problem is suspected, take the snowmo-
bile to an authorized Yamaha Snowmo-
bile dealer. If not under warranty, this
service is at the discretion and expense of
the snowmobile owner.
! WARNING
Never make the final connection to a
battery as a spark could ignite hydrogen
gases causing an explosion of the bat-
tery resulting in acid burns or blindness.
CAUTION
DO NOT attempt to service the drive
clutch and driven clutch. The drive
clutch and driven clutch must be ser-
viced by an authorized Yamaha Snow-
mobile dealer only.
Summary of Contents for SR10RDG 2015
Page 47: ...45 Snowmobile Safety Rules...
Page 51: ...49 YAMAHA EXTENDED SERVICE Y E S FOR U S A CUSTOMERS...
Page 53: ...51 NOTES...