39
SNO-442A
Installing (Dual)
1. Position the wear bar with the car-
bide (A) on the inside of ski and
loosely secure using the existing
spacer, washer, and nut; then posi-
tion the wear bar without the carbide
(B) on the outside of the ski and
loosely secure using the existing
spacer, washer, and nut.
SNO-441A
2. Tighten the nuts evenly to 2.0 kg-m
(15 ft-lb).
Adjusting Ski Stance
NOTE: Local laws and/or regula-
tions as to maximum width of the ski
stance on these snowmobiles may
be applicable. Always comply with
the maximum width laws and/or reg-
ulations when adjusting ski stance.
NOTE: Ski stance can be increased/
decreased by 25 mm (1.0 in.).
Single Wear Bar
1. Place the front of the snowmobile on
a support stand.
2. Remove the cotter pin; then remove
the slotted nut and cap screw secur-
ing the ski assembly to the spindle.
Remove the ski. Account for the ski
damper, inserts, spacers and wash-
ers.
0748-903
3. To increase ski stance, place ski
stance spacers to the outside of the
spindle and adjust the damper.
4. To decrease ski stance, place ski
stance spacer to the inside of the
spindle and adjust the damper.
5. Apply an all-temperature grease to the
non-threaded portion of the cap
screw; then slide the cap screw
through the ski accounting for the rub-
ber damper, inserts, and washers.
NOTE: Install the cap screw so the
slotted nut will be located to the
inside of the ski.
6. Apply Yamabond Red Threadlocker
to the threads of the cap screw; then
tighten the nut to 6.2 kg-m (45 ft-lb).
7. Place the cotter pin into the ski cap
screw and spread the pin.
8. Repeat procedure for the other ski.
Dual Wear Bar
1. Place the front of the snowmobile on
a support stand.
2. Remove the cotter pin; then remove
the slotted nut and cap screw secur-
ing the ski assembly to the spindle.
Remove the ski. Account for the
rubber damper, inserts, and washers.
3. To increase ski stance, place ski
stance spacer to the outside of the
spindle and adjust the damper.
4. To decrease ski stance, place ski
stance spacer to the inside of the
spindle and adjust the damper.
Summary of Contents for SR10RDG 2015
Page 47: ...45 Snowmobile Safety Rules...
Page 51: ...49 YAMAHA EXTENDED SERVICE Y E S FOR U S A CUSTOMERS...
Page 53: ...51 NOTES...
