42
En
1
Turn on the video monitor connected to this
unit.
y
• See page 44 to display the input source information.
• You can display a gray background in the OSD when there
is no video signal being input by setting “GRAY BACK”
in “OPTION MENU” to “AUTO” (see page 91).
• You can turn on or off the short message displays on the
video monitor. See pages 91 for details.
2
Rotate the
C
INPUT
selector (or set the
operation mode selector to
C
AMP
and then
press one of the input selector buttons (
1
))
to select the desired input source.
The name of the currently selected input source
appears in the front panel display and in the OSD for
a few seconds.
3
Start playback on the selected source
component or select a broadcast station.
• Refer to the instruction manuals for the source
component.
• See page 54 for details about FM/AM tuning
instructions.
• See page 58 for details about XM Satellite Radio
tuning instruction.
4
Rotate
Q
VOLUME
(or press
B
/–
)
to adjust the volume to the desired output
level.
Control range: MUTE, –80.0 dB (minimum) to
+16.5 dB (maximum)
y
See page 53 to adjust the level of each speaker.
5
Rotate the
N
PROGRAM
selector (or press
one of the sound field program selector
buttons (
N
) repeatedly) to select the desired
sound field program.
The name of the selected sound field program appears
in the front panel display and in the OSD. See
page 46 for details about sound field programs.
Sound field programs cannot be selected when the component
connected to the MULTI CH INPUT jacks is selected as the input
source (see page 43).
y
• Choose a sound field program based on your listening
preference, not merely on the name of the program.
• When you select an input source, this unit automatically selects
the last sound field program used with the corresponding input
source.
• To display information about the currently selected input source
in the OSD, see page 44 for details.
Playback
Caution
Extreme caution should be exercised when you play
back CDs encoded in DTS. If you play back a CD
encoded in DTS on a DTS-incompatible CD player,
you will only hear some unwanted noise that may
damage your speakers. Check whether your CD player
supports CDs encoded in DTS. Also, check the sound
output level of your CD player before you play back a
CD encoded in DTS.
y
To play DTS-encoded CDs when using a digital audio
connection, set “DECODER MODE” in “INPUT MENU” to
“DTS” before the playback (see page 89).
Before performing the following operations, set the operation
mode selector on the remote control to
C
AMP
.
Basic procedure
CD-R
CD
PHONO
MULTI CH
TUNER
XM
MD/TAPE
BD/HD DVD
DVD
DVR
DTV/CBL
VCR
V-AUX
D V D
Currently selected input
source
Available input sources
Note
M o v i e
S c i - F i
Currently selected sound field program
Currently selected sound field program category
