5
To start the measurement, use the cursor keys to select “Start”
and press ENTER.
The measurement will start in 10 seconds. Press ENTER to start the
measurement immediately.
Note
To stop the measurement temporarily, press RETURN and follow the procedure in “Error
messages” (p.31).
The following screen appears on the TV when the measurement finishes.
Auto Setup
Measurement Finished
Result
3 / 2 / 0.1 ch
3.0 / 10.5 m
-3.0 / +10.0 dB
OK : ENTER
1
2
3
4
1
The number of speakers (front side/rear side/subwoofer)
2
Speaker distance (nearest/farthest)
3
Adjustment range of speaker output level
4
Warning message (if available)
Note
▪ If any error message (such as E-1) or warning message (such as W-1) appears, see “Error
messages” (p.31) or “Warning messages” (p.32).
▪ A speaker with a problem is indicated by blinking of the speaker indicators in the front display.
▪ If multiple warnings are given (when operating with the front display), use the cursor keys (
q
/
w
)
to check the other warning messages.
6
Confirm the results displayed on the screen and press ENTER.
7
Use the cursor keys (
e
/
r
) to select “SAVE” and press ENTER.
Auto Setup
Start
Exit
< SAVE >
The adjusted speaker settings are applied.
Note
To finish the measurement without saving the result, select “CANCEL”.
8
Disconnect the YPAO microphone from the unit.
This completes optimization of the speaker settings.
Notice
▪ The YPAO microphone is sensitive to heat, so should not be placed anywhere where it could be
exposed to direct sunlight or high temperatures (such as on top of AV equipment).
En
30
