Firmware Update Procedure for RX-V3900
Page.2 of 6
Confirming the firmware version
Step1:
Set the
MASTER ON/OFF
button on the front panel to OFF, and confirm that
the AC power cable is properly connected to an outlet.
Step2
While pressing the
STRAIGHT
button, press (and release) the
MASTER
ON/OFF
button and then keep pressing the
STRAIGHT
key until
“
ADVANCED SETUP
” appears on the front panel display.
(Note: “
ADVANCED SETUP
” is only displayed for a few seconds.)
Step3
Rotate the
PROGRAM
selector counterclockwise to select “
VERSION
”.
Latest version would be
“VERSION 1.11”
.
If your receiver’s version is lower than above, perform the update described in
the following pages. NETWORK UPDATE is recommended if your receiver
is connected to the internet. If not, perform USB UPDATE.
If “ERROR” appears, refer to the troubleshooting procedures on page 6 and
retry the update.
STEP1
STEP2
press & hold
STEP3
