Firmware Update Procedure for RX-V3900
Page.5 of 6
Instruction for Network Update
Step1:
Set the
MASTER ON/OFF
button on the front panel to OFF, and confirm that
the AC power cable is properly connected to an outlet.
Step2:
While pressing the
STRAIGHT
button, press (and release) the
MASTER
ON/OFF
button and then keep depressing the
STRAIGHT
button until
“
ADVANCED SETUP
” appears on the front panel display.
(Note: the “
ADVANCED SETUP
” is only displayed for a few seconds.)
Step3
Rotate the
PROGRAM
knob counterclockwise to select “
FIRM UPDATE
USB
”.
Press
STRAIGHT
button to change update mode to network.
Step4
To start the firmware update, press the
MENU
button. (allow about 10mins)
Firmware reprogramming in progress
Caution!
Do to not interrupt power during the update.
Step5
When “
UPDATE OK
” appers on the display, firmware update is completed.
The receiver automatically powers off and on again in normal operation
mode.
Step6
Power OFF the unit by pressing
MASTER ON/OFF
button on the front panel.
Step7
Check the updated firmware version.
Requirement:
Network environment to be able to connect to the Internet via
RX-V3900. (For more information, refer to the owner’s manual.)
STEP1/STEP6
STEP3
STEP4
STEP2
press & hold
