23
English
Connecting External Amplifiers
If you want to increase the power output to the speakers, or want to use another amplifier, connect an external amplifier to the
PRE OUT/
MAIN IN
terminals as follows.
~
MAIN jacks
MAIN OUT
jack ....... Main channel line output jacks.
The signals output through these jacks
are affected by
BASS
,
TREBLE
,
BALANCE
, and
BASS EXTENSION
settings.
MAIN IN
jacks .......... Line input to the RX-V1 Main channel
amplifiers.
Ÿ
CENTER jacks
CENTER OUT
jack . Center channel line output jacks.
CENTER IN
jack ..... Line input to the RX-V1 Center channel
amplifier.
!
REAR CT jack
Rear Center channel line output jack.
⁄
SUBWOOFER jacks
Subwoofers reinforce very low frequencies.
MONO ....................
Main, Center and Rear channel
frequencies below 90 Hz are output
through this jack. You can also direct
DTS and Dolby Digital LFE signals to
this output.
SPLIT .....................
The
SPLIT
jacks output stereo separation
for the Main and Rear channels and a
split mono signal for the Center and LFE
channels.
Adjust the volume level of the subwoofer with the control on
the subwoofer. Subwoofer volume cannot be adjusted from this
unit. Depending on the settings in SET MENU items
1. SPEAKER SET, 3A. LFE LEVEL and 4A. LFE LEVEL,
some signals may not be output from the
SUBWOOFER
jacks.
@
FRONT
Front Effect channel line output jacks.
¤
REAR (SURROUND)
Rear channel line output jacks.
PREOUT/MAIN IN
FRONT
REAR
(SURROUND)
SUB
WOOFER
SPLIT
CENTER
IN
CENTER
OUT
MAIN
IN
MAIN
OUT
MONO
REAR CTR
Hookups
Note:
• When RCA pin plugs are connected to the
PRE OUT/MAIN IN
output jacks for output to external amplifiers, the corresponding internal amplifiers will be
muted.
