Yamaha RX-A2000, Owner'S Manual

Page: 43 / 195

CONNECTIONS
Setting up the speaker parameters automatically (YPAO)
En
43
When “Multi Position” is set to “No” in step 5
The following display appears when measurement
finishes without any problems.
Go to step 8.
When “Multi Position” is set to “Yes” in step 5
The following display appears when measurement at the
first position finishes without any problems.
Go to step 7.
7
Replace the optimizer microphone at your
choosing position and press
i
ENTER to
restart the automatic measurement.
Auto measurement restarts in 10 seconds.
Repeat step 7 until the measurement at all listening
positions are made.
The following display appears when measurement at
the last position finishes without any problems.
ENTER
SOURCE RECEIVER
AV
AUDIO
4 3 1 2
7 5 6 V-AUX
4 3 1 2
USB MULTI NET PHONO
TUNER DOCK SIRIUS
[ A ]
i
S a v e / E x i t
M e a s u r e . F i n i s h YPAO
VOLUME
> Y e s N o
M L T . P o s i t i o n 2 ?
YPAO
VOLUME
The following illustration shows how to place the
optimizer microphone to optimize the setup of this
unit for eight listening positions for example. Up to 8
listening positions can be measured.
J
1
6
8
7
4 5
1 2 3
NOTE
If a problem occurs, an error message or report is
displayed either during or after acoustic measurement.
Refer to “When an error message is displayed during
measurement” (
☞
p. 46 ), or “When a warning
message is displayed after measurement” (
☞
p. 46 ) to
resolve the problem and measure acoustics with
YPAO again.
S a v e / E x i t
M e a s u r e . F i n i s h
YPAO
VOLUME
Continues to the
next page
J
1 :
Measure from the most frequent listening position, such as
directly in front of the TV, first.