87
To use the Elite Wireless XLR Adapter:
1. Remove the wireless adapter from the Charger Base.
2. Attach a dynamic handheld microphone to the adapter, following safety
precautions and user information provided with that microphone.
3. After positioning the microphone at the distance it will be used at, unmute
it and go to the Microphone Management page of the Web UI. The XLR
adapter’s column will have a Pre-Amp gain setting once the adapter is
paired. This slider will allow different types of microphones to be integrated
with the Executive Elite system. Select the highest setting on the pre-amp
where clipping is not observed, to allow for the highest signal to noise ratio.
4. Based on the mute behavior defined for the adapter in the local web UI,
mute or un-mute the microphone by pressing the mute button on the
adapter (confirmed by flashing green or flashing red LEDs, respectively). In
push-to-talk mode, press the mute button and keep the finger there to
unmute the microphone. Removing the finger from the mute button will
mute the microphone again.
5. To turn the XLR adapter off, return the unit to the Charger Base or press
and hold the Mute button for about 10 seconds until the LED turns solid
red, then release button. The adapter can also be turned off from the local
web UI or the room control interface. In push to talk mode the adapter
cannot be shut down using the mute button.
NOTE:
Do not place the XLR adapter into the Charging base while the
handheld microphone is still attached. Place only the adapter in
the charging Base.
NOTE:
The XLR adapter does not provide phantom power. Use only
dynamic hand-held microphones with the adapter.
If the adapters are placed too far away from the Remote Antenna (depending on
the RF power setting this can be 300 feet, 90 meters, or more from the Remote
Antenna) the connection will be dropped (LEDs flash red-yellow-green-yellow)
and the microphone will mute. After 15 seconds the adapter will beep, and will
continue beeping every 30 seconds to indicating that it is out of range.
Move the adapter closer to the Remote Antenna and the connection will
automatically be re-established to its original state, and the beeping will cease.
Otherwise, the adapter will continue beeping until it turns off after about 15
minutes.
