Periodic maintenance and adjustment
70
7.
Insert the dipstick into the oil filler hole,
and then tighten the oil filler cap.
8.
Connect the oil level gauge coupler.
9.
Install the right side cover (PZ50RT /
PZ50GT / PZ50MT), or install the right
side cover and the right upper cover, and
then close the shroud (PZ50VT /
PZ50MP).
To change the engine oil
1.
Place the snowmobile on a level surface
and apply the parking brake.
2.
Start the engine, warm it up for several
minutes, and then turn it off.
3.
Remove the right side cover (PZ50RT /
PZ50GT / PZ50MT), or open the shroud
and remove the right upper cover and the
right side cover (PZ50VT / PZ50MP).
(See page 60 for the procedures.)
4.
Remove the bottom panel by removing
the bolts.
5.
Remove the right lower cover by remov-
ing the bolts.
6.
Place an oil pan under the oil tank to col-
lect the used oil.
7.
Disconnect the oil level gauge coupler.
8.
Remove the oil filler cap, and then re-
move the engine oil drain bolt and its gas-
ket to drain the oil from the oil tank.
1. Bottom panel
2. Bolt
2
1. Right lower cover
2. Bolt
1. Oil level gauge coupler
2. Oil filler cap
1. Engine oil drain bolt (oil tank)
2. Gasket
2
1
1
2
U8GKS6E0.book Page 70 Tuesday, April 17, 2012 8:48 AM
