MDX-E300
14
MDX-E300
3. How to cancel test mode
(Entry of EEPROM adjustment value)
1) Be sure to perform AUTO preliminary adjustment, AUTO adjustment and AUTO AFB adjustment.
( “
COMPLETE
” is displayed.)
2) After completing above ajustments, press the REC/PAUSE button
(REMOCON)
. (Entry to EEPROM initiates then.)
The TEST mode is completed. ( “
Test
End
” is displayed.)
3) Press the
“
v
”
button to take out the disc.
4) Turn off the power.
2. How to set to each mode
Every time the DISPLAY (forward) or EDIT (reverse) button on the remote control unit is pressed, the mode changes.
(For operation of each mode, refer to the section describing each mode.)
Since this mode is not required for servic-
ing , proceed to another mode promptly.
*
AUTO_AJST
(AUTO adjustment)
@
AUT_AFB
(AUTO AFB adjustment)
@
RST_YOBI
(RESULT preparation)
@
RESULT
(RESULT)
@
MNU_YOBI
(MANUAL preliminary adjustment)
@
MNU_AJST
(MANUAL adjustment)
@
EEPROM_SET
(EEPROM setting)
@
AUT_YOBI
(AUTO preliminary adjustment)
@
TEST MODE
1. How to enter the test mode
1) Press the
“
STANDBY/ON
”
button while pressing the
“
a
”
button and the
“
INPUT
”
button and then release your
hingers from those buttons.
“
EJECT
” is displayed.
2) Load either a disc for reproduction or a disc for recording.
“
AUTO
AJST
” is displayed.