![background image](http://html2.mh-extra.com/html/yamaha/loopfactory-an200/loopfactory-an200_manual_3217778048.webp)
48
Parameters /
Ctrl (Control) Matrix Parameter Tab
Ribbon Controller-X (for AN1x data compatibility)
For controlling with X-axis motion on a ribbon controller (left-right), and/or by incoming
MIDI messages of Control Change number 13. When Ribbon Controller-X is used, the
control change (default of 13) is treated as a "Center-Base-Controller" (center = 64).
Ribbon Controller-Z (for AN1x data compatibility)
For controlling with Z-axis motion on a ribbon controller (push-release), and/or by
incoming MIDI messages of Control Change number 12.
AN AC 1 - 8
For controlling with a specified Assignable Controller. (Refer to the instructions on
using Assignable Controllers in the owner's manual of your particular tone generator.
• The available Source for assignment may differ, depending on the selected Parameter. For
details of available parameters, see the table of Control Matrix parameters in the AN200
Owner's Manual.
• You cannot assign the same Source controller and Parameter to more than one set. If you
attempt to do so, lower-numbered sets will take priority.
• The control change numbers for AN AC 1-4 can be set with the AN Native parameters (on the
panel of the AN200). Each Preset Pattern has four pre-assigned control change numbers
using this function (refer to the AN Pattern List in the AN200 Owner’s Manual).
• The Control Change numbers for the Mod Wheel, Foot Volume, Foot Control, Footswitch, Rib-
bon Controller-X, Ribbon Controller-Z and AN AC 5-8 can be set from the AN1x System
Parameters (refer to the MIDI Data Format section in the AN200 Owner’s Manual).
• Parameter
Settings:
For a complete list of the Control Matrix's Parameters, see the AN200 Owner's Manual.
When this is set to "Off," the assigned controller has no effect. (Unavailable parameters
are "ghosted.")
• Depth
Settings:
The available settings may differ, depending on the selected Parameter. For details, see
the table of Control Matrix parameters in the AN200 Owner's Manual.
This determines the control range of the Source controller. When this is set to "Direct,"
you can directly adjust/edit the parameter assigned to the controller within its original
range.
• Pitch Bend Range Up
• Pitch Bend Range Down
Range: -24 ... +24
These two parameters let you set independently set the Pitch Bend Range for up and
down motion of the pitch bend wheel on a connected MIDI keyboard. In other words, this
allows you to set pitch bend so that moving the wheel up can make a greater (or lesser)
pitch change than moving the wheel down.