Yamaha FZ6-N 2004, Service Manual

Page: 21 / 77

–13–
CABLE ROUTING
SPEC
A To the meter.
B Either right or left side arrangement for the left han-
dlebar switch lead coupler and radiator fan motor
coupler can be accepted.
C Point the L-shape terminal to the front side of the ve-
hicle.
D Hook the starter motor lead to the alternate pawls
on the battery cover.
E To the crankshaft position sensor.
F Route the crank shaft position sensor lead above
the starter motor leads.
G Clamp the starter motor lead and crank shaft posi-
tion sensor lead. Point the projected part of the tip to
the inner side of the vehicle.
H Pass the radiator hose, coolant reservoir hose, wire
harness and starter motor lead in order through the
lower side of the vehicle.
I Set the 4-pin coupler in the connector cover after
wiring it.
J To the sidestand switch.
K To the speed sensor.
L To the A.C. magneto.
M To the oil level gauge.
N To the rear brake/light switch.
O To the neutral switch.
P Push the wire harness in the groove of the mud
guard.
Q Point the opening section of the clamp upward.
R To the rear turn signal. (right)
S To the rear turn signal. (left)
T To the license plate light.
U To the tail/brake light.
V Insert the enwinding clamp of the wire harness into
the hole of the rear frame.