Yamaha FZ6-N 2004, Service Manual

Page: 18 / 77

–10–
A To the headlight bulb.
B Route it inside (in the width direction of the vehicle)
of the left handlebar switch lead.
C To the auxiliary light socket.
D To the meter.
E Line up the left handlebar switch lead coupler and
fan motor lead coupler behind the head pipe.
F To the immobilizer.
G To the main switch.
H Place three couplers on the flange of the cover.
I To the fuel pump.
J Clamp four wire leads. There should be no exces-
sive slack on the wire leads.
K To the engine.
L To the fuel tank.
M Either installation position can be accepted, but
make sure that the leads are not crossed.
N Clamp the rear turn signal lead and license plate
light lead to the frame. Hook the clamp to the brack-
et. Pull out the lead sufficiently to the frame side and
route it along with the side of the back stay. Cut the
tip of the clamp to be between 1 and 5 mm (0.04 and
0.20 in) upward.
O Clamp the rear turn signal lead and license plate
light lead to the frame. Cut the tip of the clamp to be
between 1 and 5 mm (0.04 and 0.20 in).
P Gap between the lead and muffler should be 10 mm
(0.39 in) or more.
Q Coupler should not run on the relay assembly.
R To the tail/brake light.
S To the license plate light.
T To the rear turn signal light. (right)
U To the rear turn signal light. (left)
CABLE ROUTING
SPEC