Operation
45
2.
Operate each of the power trim and tilt
switches on the remote control and en-
gine bottom cowling to check that all
switches work.
3.
Tilt the outboard motor up and check that
the tilt rod and trim rods are extended
completely.
4.
Use the tilt support lever to lock the motor
in the up position. Operate the tilt down
switch briefly so the motor is supported
by the tilt support lever.
5.
Check that the tilt rod and trim rods are
free of corrosion or other flaws.
6.
Activate the tilt-down switch until the trim
rods have retracted completely into the
cylinders.
7.
Activate the trim-up switch until the tilt rod
is fully extended. Unlock the tilt support
lever.
8.
Tilt the outboard motor down. Check that
the tilt rod and trim rods operate smooth-
ly.
EMU36582
Battery
Check that the battery is in good condition,
and fully charged. Check that the battery con-
nections are clean, secure and covered by in-
sulating covers. The electrical contacts of the
battery and cables must be clean and proper-
ly connected or the battery will not start the
engine.
Refer to the battery manufacturer’s instruc-
tions for checks for your particular battery.
EMU30025
Filling fuel
WARNING
EWM01830
●
Gasoline and its vapors are highly flam-
mable and explosive. Always refuel ac-
cording to this procedure to reduce the
risk of fire and explosion.
●
Gasoline is poisonous and can cause in-
jury or death. Handle gasoline with care.
Never siphon gasoline by mouth. If you
should swallow some gasoline or inhale
a lot of gasoline vapor, or get some gas-
oline in your eyes, see your doctor im-
mediately. If gasoline spills on your
1. Tilt rod
2. Trim rods
1. Tilt support lever
U63P7AE0.book Page 45 Thursday, February 25, 2010 1:14 PM
