Yamaha FJR13AEV(C), Service Manual

Page: 258 / 726

HANDLEBARS
4-71
• Lead holder 2 “2”
NOTE:
• Align the projection “a” on the hand shift switch
with hole “b” on the left handlebar.
• When installing the hand shift switch, route the
left grip warmer lead “3” and left handlebar
switch lead “4” through the switch as shown in
the illustration, making sure to fasten the left
grip warmer lead with the lead holder 2.
• After installing the hand shift switch, check that
the left grip warmer lead does not interfere with
the movement of the hand shift lever.
6. Install:
• Right handlebar
• Left handlebar
NOTE:
Fit the projections on each handlebar into the
holes in the upper bracket, making sure that the
handlebars are installed in the same position.
7. Install:
• Handlebar bolts “1”
(temporarily)
• Handlebar nuts “2”
(temporarily)
8. Tighten:
• Handlebar bolts
• Handlebar nuts
NOTE:
First tighten the bolts, then tighten the nuts.
9. Install:
• Throttle grip
• Throttle cables
• Throttle cable housing “1”
• Grip end “2”
NOTE:
• Make a loop in the right grip warmer lead “3” as
shown in the illustration, making sure that the
section of the lead from the grip warmer cross-
es to the rear of the other section of the lead,
and route the lead through the throttle cable
housing.
• When installing the throttle cable housing,
align the projection “a” on the housing with the
hole “b” in the right handlebar and be sure not
to pinch the right grip warmer lead.
• There should be 1–3 mm (0.04–0.12 in) of
clearance “c” between the throttle grip and the
grip end.
a. Front position
b. Standard position
c. Rear position
1
a
b
4
3
2
a
b
c
a
b
c
a
b
c
a
b
c
a
b
c
a
b
c
a
b
c
a
b
c
T
R
.
.
Handlebar bolt
23 Nm (2.3 m·kg, 17 ft·lb)
Handlebar nut
65 Nm (6.5 m·kg, 47 ft·lb)
2
2
1
1
1
3