PERIODIC MAINTENANCE AND ADJUSTMENT
7-10
7
TIP
_
If a torque wrench is not available when
installing a spark plug, a good estimate
of the correct torque is 1/4–1/2 turn
past finger tight. However, the spark
plug should be tightened to the speci-
fied torque as soon as possible.
_
4. Install the spark plug cap.
5. Install the panel.
EAUU1470
Engine oil and oil strainer
The engine oil level should be checked
before each ride. In addition, the oil
must be changed and the oil strainer
cleaned at the intervals specified in the
periodic maintenance and lubrication
chart.
To check the engine oil level
1. Place the vehicle on the center-
stand. A slight tilt to the side can
result in a false reading.
2. Start the engine, warm it up for
several minutes, and then turn it
off.
3. Wait a few minutes until the oil set-
tles, remove the oil filler cap, wipe
the dipstick clean, insert it back
into the oil filler hole (without
screwing it in), and then remove it
again to check the oil level.
EWAU0030
WARNING
_
The muffler and muffler protector
become very hot during use. To
avoid possible burns, let the muffler
and protector cool before removing
the oil filler cap.
_
TIP
_
The engine oil should be between the
minimum and maximum level marks.
_
Tightening torque:
Spark plug:
12.5 Nm (1.25 m·kgf, 9.0 ft·lbf)
1. Engine oil filler cap
1
ZAUU0874
1YCF8199E0.book Page 10 Friday, March 22, 2013 8:34 AM
