Yamaha Fazer FZ8-SA, Service Manual

Page: 140 / 610

PERIODIC MAINTENANCE
3-11
3. Install:
• Throttle bodies
Refer to “THROTTLE BODIES” on page
7-5.
EAS20600
ADJUSTING THE EXHAUST GAS VOLUME
TIP
Be sure to set the CO density level to stan-
dard, and then adjust the exhaust gas volume.
1. Turn the main switch to “OFF” and set the
engine stop switch to “ON”.
2. Simultaneously press and hold the
“SELECT” and “RESET” buttons, turn the
main switch to “ON”, and continue to press
the buttons for 8 seconds or more.
TIP
“dI” appears on the clock LCD.
3. Press the “SELECT” button to select the
CO adjustment mode “Co “1”” or the diag-
nostic mode “dI”.
4. After selecting “CO”, simultaneously press
the “SELECT” and “RESET” buttons for 2
seconds or more to execute the selection.
5. Press the “SELECT” and “RESET” buttons
to select a cylinder.
TIP
The selected cylinder number appears on the
clock LCD.
• To decrease the selected cylinder number,
press the “RESET” button.
• To increase the selected cylinder number,
press the “SELECT” button.
6. After selecting the cylinder, simultaneously
press the “SELECT” and “RESET” buttons
for 2 seconds or more to execute the selec-
tion.
7. Change the CO adjustment volume by
pressing the “SELECT” and “RESET” but-
tons.
TIP
The CO adjustment volume appears on the
tripmeter LCD.
• To decrease the CO adjustment volume,
press the “RESET” button.
• To increase the CO adjustment volume,
press the “SELECT” button.
8. Release the switch to execute the selec-
tion.
9. Simultaneously press the “SELECT” and
“RESET” buttons to return to the cylinder
selection (step 5).
10. Turn the main switch to “OFF” to cancel the
mode.
EAS21081
CHECKING THE EXHAUST SYSTEM
The following procedure applies to all of the
exhaust pipes and gaskets.
1. Remove:
• Radiator lower bracket
Refer to “RADIATOR” on page 6-1.
2. Check:
• Exhaust pipe “1”
• Muffler “2”
Cracks/damage
→
Replace.
• Gaskets “3”
Exhaust gas leaks
→
Replace the gasket.
3. Check:
• Tightening torque