Operation
66
crushed between the outboard motor and
the clamp bracket when the outboard mo-
tor is trimmed or tilted.
(1) Make sure that the PTT TotalTilt function
is activated.
(2) Push the “
” (up) side of the PTT switch
twice quickly.
TIP:
This operation causes the outboard motor
to automatically tilt up to the fully tilted-up
position and stop.
If the tilt limiter is installed, the auto tilt up
operation causes the outboard motor to
automatically tilt up to the angle set by the
tilt limiter and stop.
The buzzer sounds before the automatic
operation begins, and sounds intermittent-
ly during automatic tilting.
Pushing the PTT switch briefly during the
automatic operation, stops the operation.
Automatic tilt-down
EWM01544
Make sure that all people are clear of the
outboard motor when tilting the outboard
motor up and down. Body parts can be
crushed between the outboard motor and
the clamp bracket when the outboard mo-
tor is trimmed or tilted.
(1) Make sure that the PTT TotalTilt function
is activated.
(2) Push the “
” (down) side of the PTT
switch twice quickly.
TIP:
This function causes the outboard motor to
automatically tilt down to the fully trimmed-
out position and stop.
The buzzer sounds before the automatic
operation begins, and sounds intermittent-
ly during automatic tilting.
Pushing the PTT switch briefly during the
automatic operation, stops the operation.
If automatic tilting does not operate
In the following situations, the PTT TotalTilt
function is deactivated and does not operate.
If you suspect a malfunction, consult your
Yamaha dealer.
The PTT unit is stuck, or foreign matter is
preventing the tilting operation.
The buzzer is malfunctioning.
The tilt sensor is malfunctioning.
EMU28063
Shallow water
EMU47840
Cruising in shallow water
The outboard motor can be tilted up partially
to allow operation in shallow water.
ECM01491
If the engine speed is suddenly in-
creased when the outboard motor is
partially tilted up, the power trim and tilt
unit could be damaged.
Do not tilt the outboard motor up so that
the cooling water inlet on the lower unit
is above the surface of the water when
setting up for and cruising in shallow
water. Otherwise severe damage from
overheating can result.
1. Cooling water inlet
1
U6KNK0E0.book Page 66 Monday, November 7, 2022 10:23 AM