8-32
8
Periodic maintenance and adjustment
NOTICE
ECAU0081
If a turn signal light bulb of different
wattage than recommended is used,
the turn signal light flashing may be
affected.
3. Remove the burnt-out bulb by
pulling it out.
4. Insert a new bulb into the socket.
5. Install the auxiliary light socket (to-
gether with the bulb) by pushing it
in.
6. Install the panel.
EAUN0490
Replacing a tail/brake light
bulb or a rear turn signal light
bulb
If a tail/brake light bulb or a rear turn
signal light bulb burns out, replace it as
follows.
Tail/brake light bulb
1. Remove panel D and E. (See page
8-9)
2. Remove the bulb socket (together
with the bulb) by turning it coun-
terclockwise and pulling the tail-
light bulb socket up at an angle.
3. Remove the burnt-out bulb by
pushing it in and turning it coun-
terclockwise.
1. Tail/brake light bulb socket
4. Insert a new bulb into the socket
by pushing it in and turn it clock-
wise until it stops.
NOTICE
ECAU0091
If a taillight bulb of different wattage
than recommended is used, it may
cause the battery to discharge or af-
fect the taillight lighting.
5. Install the bulb socket (together
with the bulb) by turning it clock-
wise.
6. Install the panel, and then close
the seat.
Rear turn signal light bulb
1. Remove panel D and E. (See page
8-9
2. Remove the bulb socket (together
with the bulb) by turning it coun-
terclockwise.
