Yamaha E115A, Service Manual

Page: 157 / 261

61U5H11 6-20
9
8
7
6
5
4
3
2
1
Drive shaft and lower case
2. Set the gear shift to the neutral position
at the lower unit. Make sure that the shift
rod is in the neutral position using a spe-
cial service tool.
3. Install the 2 dowels
1
into the lower unit
and extension
2
(E115A: Y-transom).
4. Connect the speedometer hose
3
.
5. Install the lower unit into the upper case,
and then tighten the lower case mount
bolts
4
or nuts to the specified torque.
6. Install the trim tab
5
to its original posi-
tion, and then tighten the trim tab bolt
6
to the specified torque.
å
E115A: Y-transom
7. Install the grommet
7
.
8. Install the propeller and propeller nut
8
,
and then temporarily tighten the nut.
Place a block of wood between the anti-
cavitation plate and propeller to prevent
the propeller from turning, and then tight-
en the nut to the specified torque.
w
9
Do not hold the propeller with your
hands when loosening or tightening it.
9
Be sure to disconnect the battery cables
from the battery and remove the lock
plate from the engine stop lanyard
switch.
9
Put a block of wood between the anti-
cavitation plate and propeller to prevent
the propeller from turning.
NOTE:
If the grooves in the propeller nut
8
do not
align with the propeller shaft hole, tighten the
nut until they are aligned.
69D60036
Shift rod push arm:
90890-06052
4
4
5
1
1
7
6
3
6G460270
å
2
1
1
1
1
4
Lower case mount bolt (nut) 4 :
39 N·m (3.9 kgf·m, 28.8 ft·lb)
Trim tab bolt
6
:
39 N·m (3.9 kgf·m, 28.8 ft·lb)
8
6F660420
Propeller nut
8
:
54 N·m (5.4 kgf·m, 39.8 ft·lb)
61U5H11_06_1 06.2.10 16:38 Page 21