Introduction
Preparations
Basic Operation
Advanced
Operation
Additional
Information
Appendix
46
Programming a New Remote Control Function
If you desire to program functions not included in the basic operations covered by the manufacturer code, or a manufacturer code is not
available, the following procedure needs to be performed. The possible programming area is the same as a component control area, so
buttons are programmable independently for each source component area. It is also possible to program in the main unit control area.
1
1
Place this remote control and the other remote control about
5 to 10 cm (2 to 4 in.) apart on a flat surface so that their
infrared transmitters are aimed at each other.
2
2
Select a source component.
3
3
Press
LEARN
using a ball point pen or similar object.
Do not press and hold
LEARN
longer than three seconds.
Otherwise this unit enters the Setting the Manufacture Code
mode.
4
4
Press and release the button where you want the new
function to be programmed.
5
5
Press and hold the button on the other remote control that
has the function you want to program into this remote
control until “OK” appears in the display window.
• “NG” appears in display window when programming is
not done correctly. Repeat step 4 until “OK” appears in
the display.
6
6
Repeat Steps 4 and 5 to program additional functions.
7
7
Press
LEARN
again to exit the Learn mode.
Notes:
• If you do not press any button within 30 seconds, the learning process is canceled.
• This remote control transmits infrared rays. If the other remote control also uses infrared rays, this remote control can learn most of the other remote
control’s functions. However, you may not be able to program some special signals or extremely long transmissions. (Refer to the operation instructions for
the other remote control.) When the memory is full, “FULL” appears in the display window, and this remote control cannot acquire any more functions.
Clear unnecessary programmed functions to allow the unit to acquire new functions.
• Even if the batteries in the other remote control have enough power to transmit signals for operation, they may not have enough power to transmit signals to
this remote control.
• When the remote controls are either too close together or too far apart, you may not be able to program this remote control.
• Direct sunlight interferes with infrared rays.
• “ERROR” appears in the display window in the following conditions: when pressing more than one button at once; and when
MACRO ON/OFF
is
switched to another position.
5~10 cm (2 to 4 in.)
LEARN
Flashes
alternately
LEARN
Remote Control Features
