15
14. Pair the input channels
If the signals being played back from the VTR are stereo, using the DM1000’s Pair
function will allow you to handle them as a stereo signal, and control them by a
single fader and ON/OFF switch.
You can pair the channels either by using the [SEL] keys or by making the setting
in the LCD screen. For details, refer to the DM1000 owner’s manual.
If the channels of a stereo input signal are panned to left and right, the monitor
signal will also be stereo. With the factory settings, panning two paired channels to
far left and far right will raise the level by approximately 3 dB in comparison to
when the channels are centered. However, you can make settings so that the level
does not change when paired channels are fully panned. This setting is made in the
PREFER1 page of the SETUP screen. To access this page, press the DISPLAY
ACCESS section [SETUP] key repeatedly to access PREFER1 (PREFERENCE1).
If Nominal Pan is checked, the level will not change when panned fully.
