105
• Be careful not to confuse parts, and be sure to install all parts in the
correct direction. Please assemble in accordance with the sequence
given below.
• Assembly should be carried out by at least two persons.
• Be sure to use the correct screw size, as indicated above. Use of
incorrect screws can cause damage.
• Be sure to tighten all screws upon completing assembly of each unit.
• To disassemble, reverse the assembly sequence given below.
The parts shown in the “Assembly Parts” illustration will
be used. Follow the assembly instructions and select
the parts as needed.
Keyboard Stand Assembly
(DGX-500 only)
Have a phillips-head (+) screwdriver ready.
w
Joint connectors
q
6 x 70 mm round head screws
Z
Attach the stand bases.
Making sure that the boards are facing the proper direc-
tion (the holes should face inside), insert the joint connec-
tors
w
into the holes as shown. The joint connectors have
been installed properly if you can see a plus mark on the
connector.
Attach the stand bases to the rear of the side boards,
using the 6 x 70 mm round head screws
q
.
1
q
6 x 70 mm round head screws (4 pcs.)
w
Joint connectors (4 pcs.)
e
3.5 x 16 mm tapping screws (12 pcs.)
r
6 x 30 mm round head screws (4 pcs.)
t
5 x 16 mm round head screws (4 pcs.)
y
Angle brackets (4 pcs.)
Back board
Side boards
Stand bases
■
Assembly Parts (DGX-500 only)