9
CLP-265GP
11-7 MV Circuit Board
11-7-1 Remove the slide knob (MASTER VOLUME). (Fig.12)
11-7-2 Remove the two (2) screws marked [50A]. The panel
holder assembly can then be removed. (Fig.13)
11-7-3 Remove the four (4) screws marked [50D]. The MV
circuit board can then be removed. (Fig.13)
*
When assembling each circuit board, confirm the LED
heads have gone into the panel holes correctly.
12.
End Block Assembly (L,R)
(Time required: About 9 minutes each)
12-1
Remove the top board assembly (L) . (See procedure 2.)
12-2
Remove the top board assembly (S). (See procedure 3.)
12-3
Remove the key cover assembly. (See procedure 5.)
12-4
Remove the panel assembly. (See procedure 10.)
12-5
Remove the screw marked [S11] and the washer marked
[S22] for each side. The end block assemblies L and R
can then be removed. (Fig.12, Fig.14)
Panel Assembly
[S01]
[S10]
[S10]
Slide Knob
(MASTER VOLUME)
End Block Assembly L
End Block Assembly R
[S11][S22]
[S11][S22]
[S01]: Bind Head Tapping Screw-1 3.5X12 MFZN2W3 (WE970900)
[S10]: Bind Head Tapping Screw-B 4.0X10 MFZN2W3 (WE974500)
[S11]: Bind Head Tapping Screw-B 4.0X20 MFZN2W3 (WH513800)
[S22]: Flat Washer 4.0X8X0.8 MFZN2W3 (WF578600)
13.
Power Switch Assembly
(Time required: About 10 minutes)
13-1
Remove the top board assembly (L) . (See procedure 2.)
13-2
Remove the top board assembly (S). (See procedure 3.)
13-3
Remove the key cover assembly. (See procedure 5.)
13-4
Remove the panel assembly. (See procedure 10.)
13-5
Remove the end block assembly R. (See procedure 12.)
13-6
Remove the two (2) screws marked [8]. The power
switch assembly can then be removed. (Fig.14)
14.
HP Jack Assembly, HP Circuit Board
(Time required: About 10 minutes)
14-1
Remove the top board assembly (L) . (See procedure 2.)
14-2
Remove the top board assembly (S). (See procedure 3.)
14-3
Remove the key cover assembly. (See procedure 5.)
14-4
Remove the panel assembly. (See procedure 10.)
14-5
Remove the end block assembly L. (See procedure 12.)
14-6
Remove the three (3) screws marked [S01]. The HP jack
assembly can then be removed. (Fig.14)
14-7
Remove the two (2) nuts marked [3]. The HP circuit
board can then be removed from the HP jack assembly.
(Fig.14)
(Fig.12)
MV
PNL
PNR
[50B]
[50C]
[50A]
Panel Holder Assembly
[50D]
[50E]
[50F]
(Fig.13)
[50A-F]: Bind Head Tapping Screw-B 3.0X8 MFZN2W3 (WE774300)
