35
CLP-120
If the correct switch is pressed, the sine wave sounds on the pitch shown in the
Table 2 and the 7segment LED indicates the next number.
In addition, the LED lights up as for the LED-attached switch.
If the wrong switch is pressed, the 7segment LED indicates ‘
nG
’.
After the last switch is checked, the 7segment LED indicates ‘
PAS
’.
21
(21
: All LED ON
All LED ON Check
8.8.8.
Confirm that all LEDs on the panel light up.
31
(31
: Soft Pedal Check
Soft Pedal Check
PE1
When the soft pedal is depressed, the sine wave of C3 sounds and 7segment
LED indicates ‘
Str
’.
Str
When the pedal is released, the sine wave of C4 sounds and 7segment LED in-
dicates ‘
PAS
’.
PAS
32
(32
: Sostenuto Pedal Check
Sostenuto Pedal Check
PE2
When the sostenuto pedal is depressed, the sine wave of C3 sounds and 7seg-
ment LED indicates ‘
Str
’.
Str
When the pedal is released, the sine wave of C4 sounds and 7segment LED in-
dicates ‘
PAS
’.
PAS
33
(33
: Damper Pedal Check
Damper Pedal Check
PE3
When the damper pedal is depressed, the sine wave of C3 sounds and 7segment
LED indicates ‘
Str
’.
Str
When the pedal is released, the sine wave of C4 sounds and 7segment LED in-
dicates ‘
PAS
’.
PAS
37
(37
: MIDI Check
MIDI Check
PAS
Connect MIDI IN and MIDI OUT terminal by a MIDI cable and execute the
test.
Confirm that the 7segment LED indicates ‘
PAS
’.
38
(38
: To Host Check
TO HOST Check
PAS
Short-circuit pin3 and pin5, pin6 and pin8 of TO HOST terminal respectively
and execute the test.
Select the position of HOST SELECT switch according to the 7segment LED
display, and confirm that the following note sounds and 7segment LED indi-
cates ‘
PAS
’.
PC-1 position: C3, PC-2 position: C4, MAC position: C5
41
(41
: ROM Check2
ROM Check 2 (for factory test only)
42
(42
: RAM Check2
RAM Check 2 (for factory test only)
43
(43
: Wave ROM Check2
Wave ROM Check 2 (for factory test only)
46
(46
: Backup Check2
Backup Check 2 (for factory test only)
47
(47
: Factory Set
Factory
FAC
Initializes all RAMs to the factory preset data.
48
(48
: Test Exit
Exit the test program and return to the play mode.
Note: 0dBm = 0.775V
