![background image](http://html1.mh-extra.com/html/yamaha/apex-rx10rz/apex-rx10rz_owners-manual_3131366032.webp)
Control functions
26
ESU10975
Adjusting the spring preload of the
center shock absorber and the rear
torsion springs (RX10MT), or the rear
shock absorber (RX10R / RX10LT)
The spring preload can be adjusted by turning
the adjusting nut on the center shock absorb-
er and the adjusters on the rear torsion
springs (RX10MT), or adjusting ring (RX10R /
RX10LT) on the rear shock absorber. Adjust
the spring preload as follows.
Center shock absorber (RX10MT)
1.
Loosen the locknut.
2.
To increase the spring preload and there-
by harden the suspension, turn the ad-
justing nut in direction (a). To decrease
the spring preload and thereby soften the
suspension, turn the adjusting nut in di-
rection (b).
TIP
The spring preload setting is determined by
measuring distance A, shown in the illustra-
tion. The longer distance A is, the higher the
spring preload; the shorter distance A is, the
lower the spring preload.
3.
Tighten the locknut to the specified
torque.
NOTICE:
Always tighten the
locknut against the adjusting nut, and
then tighten the locknut to the speci-
fied torque.
[ECS00860]
Rear torsion springs (RX10MT)
WARNING
EWS00750
The left and right spring preloads must be
adjusted to the same setting. Uneven set-
tings can cause poor handling and loss of
stability.
To increase the spring preload and thereby
harden the suspension, turn the adjuster in di-
rection (a). To decrease the spring preload
and thereby soften the suspension, turn the
adjuster in direction (b).
1. Spring preload adjusting nut
2. Distance A
3. Locknut
(a)
(b)
2
1
3
Spring preload setting*:
Minimum (soft):
115.5 mm (4.55 in)
Standard:
116.5 mm (4.59 in)
Maximum (hard):
126.5 mm (4.98 in)
* Distance A changes 1.5 mm (0.06 in)
with each full turn of the adjusting nut.
Tightening torque:
Locknut:
42 Nm (4.2 m·kgf, 30 ft·lbf)
1. Spring preload adjuster
(a)
(b)
U8FP15E0.book Page 26 Thursday, July 23, 2009 11:01 AM