![background image](http://html1.mh-extra.com/html/yamaha/apex-rx10rz/apex-rx10rz_owners-manual_3131366020.webp)
Control functions
14
3.
Turn the main switch to the on position,
and then, after 5 seconds, release the
“SELECT” button.
4.
Push the “RESET” button to select the
desired display brightness level, and then
push the “SELECT” button. The normal
display returns when the “SELECT” but-
ton is released.
TIP
If the main switch is turned to the off position
or the engine is started before completing the
procedure, the setting is not applied.
ESU10410
High beam indicator light “
”
The high beam indicator light comes on when
the high beams of the headlights are switched
on. (See page 18 for headlight beam switch
operation.)
ESU10472
Low coolant temperature indi-
cator light “
”
The low coolant temperature indicator light
comes on when the coolant temperature is
low and informs the rider that the snowmobile
should be warmed up. After the engine is
started, warm it up until the indicator light
goes off.
The snowmobile can be operated normally af-
ter the indicator light goes off.
TIP
Drive the snowmobile at low speeds when the
low coolant temperature indicator light is on. If
the engine speed is too high, maximum en-
gine speed is reduced to protect the engine.
ESU10424
Fuel meter and grip/thumb
warmer level indicator
The fuel meter and grip/thumb warmer level
indicator have eight segments which show
the amount of fuel remaining in the fuel tank,
the grip warmer level, or the thumb warmer
level.
1. “SELECT” button
2. “RESET” button
3. Display brightness level
1. High beam indicator light “
”
1. Low coolant temperature indicator
light “
”
U8FP15E0.book Page 14 Thursday, July 23, 2009 11:01 AM