Yamaha 2011 WR250FA, Owner'S Service Manual

Page: 73 / 316

2-33
CABLE ROUTING DIAGRAM
1. Clamp
2. Positive battery lead
3. Battery
4. Negative battery lead
5. Taillight coupler
6. CDI unit coupler (6-pin)
7. CDI unit coupler (3-pin)
8. CDI unit coupler (6-pin)
A. Fasten the wire harness, negative battery
lead and starter motor lead to the upper en-
gine bracket (left side). Locate the clamp
end facing toward the upper side of the
frame with the tie end cut off on the inside
of the frame.
B. Fasten the wire harness, negative battery
lead and starter motor lead to the upper en-
gine bracket (left side). Locate the clamp
end facing toward the upper side of the
frame with the tie end cut off on the inside
of the frame. Clamp the wire harness and
negative lead at the marking.
C. Pass the starter motor lead through the
hole in the relay holder.
D. Fit the cover securely.
E. Connect the wire harness to the starter re-
lay.
F. Fasten the catch tank breather hose and
catch tank hose to the rear frame. Clamp
them close to where they are joined to the
frame. Fasten the pipe tightly enough not
to crush it. Locate the clamp end facing to-
ward the rear of the frame with the tie end
facing downward.
G. Fasten the (three) CDI unit leads and tail-
light lead to the rear frame. Locate the
clamp end facing toward the upper side of
the frame and cut off the tie end.
H. Connect the negative battery lead to the
battery negative terminal.
I. Connect the negative battery lead to the
wire harness.
J. Fasten the wire harness to the rear frame.
Locate the clamp end facing toward the up-
per side of the frame and the tie end toward
the inside of the frame. Clamp the wire har-
ness at the marking.
K. Pass the wire harness, starter relay lead,
starting circuit cut-off relay lead and nega-
tive battery lead through the hole in the re-
lay holder.
L. Fasten the (three) CDI unit leads and tail-
light lead to the rear frame. Locate the
clamp end facing toward the lower side of
the frame and cut off the tie end.
M. Fasten the taillight lead to the rear frame.
Locate the clamp end facing toward the up-
per side of the frame and cut off the tie end.
N. Do not allow the taillight lead to slacken.
O. Locate the CDI unit lead between the CDI
unit and rear fender.
P. Locate the CDI unit coupler in the clear-
ance between the upper side of the CDI
unit and lower side of the catch tank stay.
Q. Locate the CDI unit lead between the CDI
unit and rear frame.