Yamaha 2006 FJR1300AS, Service Manual

Page: 70 / 150

SHIFT ACTUATOR AND SHIFT ROD
– 61 –
▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲▲▲
ET2D21011
INSTALLING THE LEFT FOOTREST
ASSEMBLY
1. Install:
• Sidestand
• Left footrest assembly
NOTE:
Install the left footrest assembly/sidestand bolts
“1”, left footrest assembly bolts (M8) “2” and left
footrest assembly bolt (M10) “3” temporarily and
then tighten them to the specified torques in the
proper tightening sequence as shown.
ET2D21012
INSTALLING THE SHIFT ACTUATOR
1. Install:
• Shift actuator
▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼▼▼
a. Install the shift actuator front bolt “1” tempo-
rarily.
b. Tighten the shift actuator rear bolt “2”, and
then tighten the front bolt “1” to specification.
c. Connect the shift actuator motor coupler and
shift actuator sensor coupler.
d. Pass a suitable 5 mm diameter rod “3”
through the holes in the rear shift arm and
shift actuator to secure the shift rod.
e. Install the shift rod “4”.
NOTE:
Check that the hole “a” in the shift rod is aligned
with the hole “b” in the front shift arm. If the holes
are not aligned, loosen the shift rod rear locknut
“5” and front locknut “6”, and then turn the shift
rod to adjust its length.
f. Tighten the shift rod bolts to specification.
g. If the shift rod front locknut and rear locknut
were loosened, tighten them to specification.
T
R
.
.
Left footrest assembly/sidestand
bolt
65 Nm (6.5 m·kg, 47 ft·lb)
LOCTITE
®
Left footrest assembly bolt (M8)
28 Nm (2.8 m·kg, 20 ft·lb)
Left footrest assembly bolt (M10)
49 Nm (4.9 m·kg, 35 ft·lb)
3
2
1
2
1
3
T
R
.
.
Shift actuator rear bolt
20 Nm (2.0 m·kg, 14 ft·lb)
Shift actuator front bolt
20 Nm (2.0 m·kg, 14 ft·lb)
Direction “c”
Shift rod length is increased.
Direction “d”
Shift rod length is decreased.
T
R
.
.
Shift rod bolt
10 Nm (1.0 m·kg, 7.2 ft·lb)
2
1
3
4
5
6
c
d
a
b