Yamaha 2006 FJR1300AS, Service Manual

Page: 41 / 150

ENGINE
– 32 –
b. Turn the main switch to “ON” and check that
the transmission is in neutral.
c. Add the recommended clutch fluid to the
proper level.
d. Install the clutch fluid reservoir diaphragm.
e. Connect the vacuum/pressure pump gauge
set “2” tightly to the bleed screw “3”.
f. Loosen the bleed screw.
g. Pump out the clutch fluid using the vacu-
um/pressure pump gauge set.
h. Tighten the bleed screw.
i. Disengage the clutch by turning the manual
clutch operation bolt “4” in direction “a” until it
stops.
j. Loosen the bleed screw and then retighten it.
k. Engage the clutch by turning the manual
clutch operation bolt in direction “b” until it
stops.
NOTE:
The following illustration shows the manual
clutch operation bolt when viewed from the rear
of the vehicle with the swingarm removed.
l. Repeat steps (i) to (k) until all of the air bub-
bles have disappeared from the clutch fluid in
the plastic hose of the vacuum/pressure
pump gauge set.
m. Tighten the bleed screw to specification.
n. Manually engage and disengage the clutch
30 times using the manual clutch operation
bolt.
o. Add the recommended clutch fluid to the
proper level.
Refer to “CHECKING THE CLUTCH FLUID
LEVEL” on page 31.
▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲▲▲
3. Check:
• Pressure plate stroke
▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼▼▼
a. Remove the pickup rotor cover bolts “1”.
b. Remove the clutch cover “2”.
Refer to “CLUTCH” in chapter 5. (Manual
No.: 3P6-28197-E0)
c. Manually engage and disengage the clutch
using the clutch operation bolt “3” five times,
each time for less than 1 second.
NOTE:
Turn the clutch operation bolt in a continuous
motion, without allowing the pressure plate to
stop in mid-stroke.
Vacuum/pressure pump gauge
set
90890-06756
Mityvac brake bleeding tool
YS-42423
1
3
2
T
R
.
.
Bleed screw
6 Nm (0.6 m·kg, 4.3 ft·lb)
4
b a
2
1