54
T
ROUBLESHOOTING
If errors occur, check first whether you can correct the problem yourself.
The following overview may help you.
Never try to repair the device yourself. Contact our service centre
or other qualified personnel if a repair is necessary.
PROBLEM
POSSIBLE CAUSE / REMEDY
GENERAL INSTRUCTIONS
The front control buttons do not
work
Firstly carry out initial setup as the buttons on the front of the device are
locked until this has been carried out.
No standby display
Check the mains connection: Is the plug firmly inserted in the mains
socket?
The player does not work
Press
STANDBY/ON
on the remote control or device.
If the device has been disturbed by a storm, static charge or other
external factor try the following:
Press
STANDBY/ON
on the device (Standby mode). Then pull out the
mains cable and plug it back in.
The disc does not play even
though
PLAY
has been pressed,
or stops again immediately
Is the disc inserted with the title (printed) side facing upwards?
Check whether the disc is damaged by trying another disc. If the disc is
dirty, clean it carefully, wiping it from the centre to the edge with a soft,
dry cloth.
Does the inserted disc have a format that can not be played?
For commercial DVDs: Does the DVD have the correct regional code (2)?
If condensation has formed in the device: give the player one to two
hours to dry off.
The device does not respond to
the remote control
Check whether the batteries need changing and have been inserted
correctly. Remove anything which may be blocking the signal between
the infrared transmitter, the remote control and the device's sensor.
Is the distance between the remote control and the player too great (over
7m)?
No picture
Are the cable connections between the DVD and television correct and
undamaged?
Is the television switched on?
Have you selected the video channel on the television?
Has the correct function been selected (DVD)?
Have you selected the correct video output on the DVD player?
Have you selected the
Y C r C b / R G B O f f
option in
V I D E O - S E T U P
but
the TV is connected to the DVD/HDD recorder via a SCART cable?
To restore the picture connect the video cinch output of the DVD/HDD
recorder to the video cinch input of the TV (yellow cinch plug) and if
necessary set the correct input on the TV.
Then in
V I D E O - S E T U P
select
R G B O n
again.
Do you need to carry out the channel scan again?
Summary of Contents for DVR-9300HX
Page 1: ...Manual DVR 9300HX ...
Page 59: ......
