39
YA3200-210723
EN
FR
NL
DE
EN
NOTICE
Make sure to keep the 2 middle screws
fastened.
E.6
Carefully lift the security hinge at the backside
to unlock the Solar pole from the ground.
WARNING
Mind your hands! Risk of trapping
hand/finger. Make sure no hands are near the
bottom of the Solar pole when moving it.
E.7
Place a supporting object as indicated in the
image. Carefully lower the Solar pole with three
people.
WARNING
Lifting hazard! Single person lift could
cause injury. Work with three people when lowering
the Solar pole.
E.8
Dismount the Solar panel from the profiles.
E.9
Disconnect the cables between the Solar panel
and the Solar pole.
NOTICE
You can now install the new Solar panel
following the installation steps, starting from step
D.8.
SERVICE
SUPPORT
For questions, comments or help you can always
contact the Yalp head-office in the Netherlands:
Yalp
Nieuwenkampsmaten 12
7472 DE Goor
The Netherlands
+31 (0) 547 289 410
[email protected]
For contact details of Yalp distributors or offices,
please go to Yalp.com or check the distributors
overview at store.yalp.com.
CLEANING & MAINTENANCE
WARNING
Follow the instructions in this section
closely when servicing the product. Failure to
follow these instructions may cause serious injury
or damage.
WARNING
Always be sure that the product
is powered off before attempting to perform
inspection or maintenance.
WARNING
When servicing the product,
use identical replacement parts only. Use of
unauthorized parts may cause serious injury or
damage.
• Use a mild soap and a non-scratching cloth to
clean the product every 3 months
• The product should be inspected for damaged
or missing parts on a regular basis
• When parts are damaged or missing, the
product should be disconnected and the parts
should be corrected, repaired or replaced to
prevent injuries
• Tighten the bolts every 6 months to prevent
loose bolts
• In case of surface corrosion: clean, sand and
repair with filler and paint
DISCARD
DISASSEMBLY
WARNING
Make sure that the product is
powered off to avoid electrocution.
WARNING
The disassembly should be done by a
certified installer according to local regulations on
electrical safety (e.g. NEN 1010).
CAUTION
Use protection for the parts after
disassembling and during transportation.
NOTICE
If you want to reinstall the product at a
new location make sure to check all disassembled
parts to see if they can be reused. Spare parts can
be ordered.
Summary of Contents for SOLAR
